Search

Runner up: Thingiverse Ornament Challenge

'Tis the season! My Elf ornament that I remixed from my Gramps character was featured on the Thingiverse Ornament Challenge and was one of the runner ups! I won a spool of MakerBot PLA filament. Bre Pettis also talks about all the 3D prints from the challenge and even shows my little guy. There's a video below! Studio 360: 3D Printing | The Elf aka Little Helper Ornament (19 minute mark) #3DPrinting #3D #3DPrinter #ZBrush #expo #events #contests #3dprinted #characterdesign #Thingiverse #MakerBot #holidays #xmas #elf #ornaments #PLA #Christmas

3rd Place: MakerBot Academy Math Manipulative Challenge

I placed 3rd in this challenge. I created a Math Spinner Toy that allows students to mix and match numbers to practice addition, subtraction, multiplication, and division equations. My award for 3rd Place was MakerBot PLA filament. https://thejournal.com/articles/2013/12/05/makerbot-thingiverse-names-winners-of-math-manipulative-challenge.aspx?cid=dlvr.it https://www.makerbot.com/media-center/2013/12/02/thingiverse-makerbot-academy-math-manipulative-challenge-results#sthash.RXu9bVNV.dpuf #contests #3dprinting #3ddesign #3dprinted #3dprinter #MakerBot #Thingiverse #productdesign

 

© 2001 - 2020 By Christina Chun